Universe Sandbox

Universe Sandbox => Universe Sandbox ² | Discussion => Topic started by: Rainbow on February 03, 2014, 05:01:56 PM

Title: correct water level is?
Post by: Rainbow on February 03, 2014, 05:01:56 PM

0.542 is not correct，Fourth graph The city proper light, the third picture the wrong city light

Title: Re: correct water level is?
Post by: gabriel.dac on February 03, 2014, 06:28:31 PM

Uhh what?

Title: Re: correct water level is?
Post by: Darvince on February 03, 2014, 08:05:46 PM

The water level for Earth, 0.542, is slightly too high as up to about 50 feet is submerged in water.

Title: Re: correct water level is?
Post by: gabriel.dac on February 03, 2014, 10:19:37 PM

I can hardly see it. This is a minor issue, there is no need to start a whole thread about it. Just post it in the screenshots thread, like I did several times

Title: Re: correct water level is?
Post by: Josh on February 04, 2014, 12:35:28 PM

I've noticed that the water is a bit high as well, although I assume it's a slight problem when it comes to the maps and water elevation. I'm sure it'll be fixed eventually if possible.  :)

Title: Re: correct water level is?
Post by: blotz on February 04, 2014, 06:51:51 PM

yup. can't wait for water lever for other planets

Title: Re: correct water level is?
Post by: smjjames on February 10, 2014, 05:46:31 AM

Quote from: gabriel.dac on February 03, 2014, 10:19:37 PM

I can hardly see it. This is a minor issue, there is no need to start a whole thread about it. Just post it in the screenshots thread, like I did several times

It's pretty noticeable if you look at Florida. Also Bangladesh I think.

Title: Re: correct water level is?
Post by: WitheHole18 on February 10, 2014, 09:22:53 AM

Mega Tsunami ;D

Title: Re: correct water level is?
Post by: Dan Dixon on February 10, 2014, 07:17:11 PM

Thanks for pointing this out Rainbow.  :)

Quote from: bong on February 04, 2014, 06:51:51 PM

yup. can't wait for water lever for other planets

You can add water to rocky planets already... just adjust the water level slider.

And ultimately you'll be able to specify the water amount (volume/mass) and the 0-1 slider will go away.